6-Foot Walkway Arbor Material Takeoff

6-Foot Walkway Arbor Calculator: 4-Post Archway Takeoff

A 6-foot wide, 7-foot tall 4-post garden entrance arbor (wide enough for a wheelbarrow and lawn mower) requires four 10-foot 4×4 posts buried 24 inches deep, two 6-foot 2×6 header rails, and 15 horizontal climbing slats spaced 6 inches apart.

4×4 Corner Posts

4 posts (10 ft)

7 ft clearance + 24″ buried

Header Crossbars

2 rails (6 ft)

2×6 cedar or treated beams

Climbing Slats (6″)

15 slats (6 ft)

6″ on-center lattice spacing

Exterior Fasteners

76 screws

Structural lags + slat screws

Customize or Adjust This 6-Foot Walkway Arbor Project

Pre-filled with standard 6-Foot Walkway Arbor measurements. Change depth or waste margins below to update quantities in real time.

Post length

9 ft

Beam length

6 ft

Slats

13

  • Posts (9ft)

    4 pcs
  • Beam (6ft)

    1 board
  • Lattice / slats

    13 pcs
Enter your local prices to see an estimated cost.

6-Foot Walkway Arbor Material Takeoff Breakdown

ComponentLumber SizePieces NeededNotes
Corner Posts4×4 Ground Contact (10 ft)4 postsSet 24″ deep in concrete
Main Header Beams2×6 Cedar or Treated (8 ft)2 boardsCut to 6 ft (or 7 ft w/ 6″ overhang)
Lattice Slats1×2 or 2×2 Cedar (8 ft)15 boardsSpaced 6″ on-center
Concrete Footings80-lb Concrete Mix8 bags2 bags per post hole

Contractor & Builder Notes for 6-Foot Walkway Arbor

  • ✓Square the four post holes using the 3-4-5 right-triangle method (or measure both diagonals until they match within 1/8 inch) before pouring concrete so the overhead rafters sit square.

Frequently Asked Questions: 6-Foot Walkway Arbor

How tall should a garden walkway arbor be?

Build the overhead crossbars at least 7 feet (84 inches) above the finished path so hanging wisteria, roses, or grape clusters still leave 6 ft 4 in of walking headroom.